02-18-2009 06:17 AM - edited 03-11-2019 07:52 AM
Hi Friends, I'm new with Cisco ASA/PIX, in fact i'm new in networking, when i'm triyng send this line to the PIX i get this message error, when i try to creane a nat in the inside with the access list no-nat
ERROR: access-list has protocol or port
02-18-2009 06:21 AM
This document should help you:
http://www.cisco.com/en/US/products/ps6120/products_configuration_example09186a008046f31a.shtml#NEX1
02-18-2009 06:25 AM
You can only do NAT 0 with IP Protocol.
02-18-2009 04:24 PM
Thxs for yours posts I'll take a look a yours recommendations.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide
Log in to Community
