Call to Directory Number non configured

Unanswered Question
Feb 18th, 2009
User Badges:

With a CallManager 4.2 if I call a directory number not configured I receive a message that the number is not receable. With CallManager 6.1 if I do the same as above I hear the free ring tone.

Any Idea?

Thanks

Giovanni

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
Chris Deren Wed, 02/18/2009 - 07:30
User Badges:
  • Super Silver, 17500 points or more
  • Hall of Fame,
  • Cisco Designated VIP,

    2017 IP Telephony, Contact Center, Unified Communications

The message you hear is an announciator, you probably don't have it configured properly on CM 6.


Chris

gbressanin Wed, 02/18/2009 - 07:45
User Badges:

Hi Chris,


I forgot to specify that the problem is for calls from outside.

I wrote "receive a message" but I want to say that I receive something ( message, special tone ... from PO ) that inform me about the wrong number. I think the CallManager send a "NAK" for the number not configured. With CM 6.1 this doesn't happen.


Giovanni

Actions

This Discussion