ACE 4700 - Cannot Ping the Alias

Unanswered Question

I cannot ping my alias addresses. I can ping the actual interface addresses but not the alias. When I look at the ARP entry on the switch it's connected to for the alias, it comes up INCOMPLETE.

Below is my config.

interface gigabitEthernet 1/1

description Fault Tolerant Port

ft-port vlan 990

no shutdown

interface gigabitEthernet 1/2

shutdown

interface gigabitEthernet 1/3

shutdown

interface gigabitEthernet 1/4

switchport trunk allowed vlan 10,112,200,254

no shutdown

resource-class RC1

limit-resource all minimum 20.00 maximum unlimited

limit-resource sticky minimum 8.00 maximum unlimited

boot system image:c4710ace-mz.A1_7b.bin

hostname atl-ace-01

access-list ALL line 8 extended permit ip any any

class-map type management match-any PING

2 match protocol icmp any

class-map type management match-all SNMP-ALLOW_CLASS

2 match protocol snmp source-address 10.150.100.202 255.255.255.255

class-map type management match-any remote_access

2 match protocol xml-https any

4 match protocol icmp any

5 match protocol telnet any

6 match protocol ssh any

7 match protocol http any

8 match protocol https any

9 match protocol snmp any

policy-map type management first-match AllowICMP

class PING

permit

policy-map type management first-match SNMP-ALLOW_POLICY

class SNMP-ALLOW_CLASS

policy-map type management first-match remote_mgmt_allow_policy

class remote_access

permit

interface vlan 200

ip address 10.10.200.110 255.255.254.0

alias 10.10.200.120 255.255.254.0

peer ip address 10.10.200.111 255.255.254.0

access-group input ALL

service-policy input remote_mgmt_allow_policy

service-policy input SNMP-ALLOW_POLICY

service-policy input AllowICMP

no shutdown

ft interface vlan 990

ip address 192.168.254.1 255.255.255.0

peer ip address 192.168.254.2 255.255.255.0

no shutdown

ft peer 1

heartbeat interval 250

heartbeat count 10

ft-interface vlan 990

ip route 0.0.0.0 0.0.0.0 10.10.201.254

context Exchange-CAS

allocate-interface vlan 112

allocate-interface vlan 254

member RC1

ft group 1

peer 1

priority 200

peer priority 190

associate-context Exchange-CAS

inservice

I have this problem too.
0 votes
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.

Actions

This Discussion