Detector module loadbalancing method ?

Unanswered Question
Feb 19th, 2009

We have a three detector module is seated in c6509 chassis.

we must detect 8 giga interface using only three detector module.

In document, there are two method of detector module capture traffic. first is monitor session and vacl,

in monitor session, we can't use due to limited local session number, so we must use VACL to loadbalancing detector module

we configured the detector module like below:

ip access-list extended myacl

permit ip any any

vlan access-map vacl 10

match ip access myacl

action forward capture

vlan filter vacl vlan-filter 10,20,30,40,50,60,70,80,

anomaly-detector-module 3 capture

anomaly-detecotr-module 3 capture allowed-vlan 10,20,30,40,50,60,70,80

we started the traffic and monitored the traffic state in c6509 msfc. however the traffic is injected to detector module like all same traffic, it's not load-balancing, it just span traffic to other detector module,

the requirement our want is to loadbalancing detector module like ECMP, just packet-by-packet on each detector module.

It is possible? if possible How could I configure on MSFC to loadbalance traffic?

I appreicate if you give to me answer as soon as possible.

thank you.

I have this problem too.
0 votes
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.

Actions

This Discussion