Enable debugging for a running CSDiscovery process?

Unanswered Question
Feb 19th, 2009
User Badges:
  • Blue, 1500 points or more

I've got problems with a discovery process that will not finish after discovering most or all of the devices . Around 6000 devices will be discovered. When I enable debugging (Discovery Framework) beside the fact that the log file will be quite large the process runs for days.

As I expect the failure to be at the end of the discovery process, is it possible to enable debugging just at the end (around 5500 devices) ? When I enable debugging a pop-up states that debugging will be activated in 60 sec, but will the currently running CSDiscovery proceess fully account for these settings?


  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
Joe Clarke Thu, 02/19/2009 - 15:19
User Badges:
  • Cisco Employee,
  • Hall of Fame,

    Founding Member

No. This problem has been plaguing us for a while. The only way to isolate it will be to enable framework debugging for the whole Discovery, then get a full thread dump when the process has locked up. The problem appears to be a thread that dies unexpectedly.

Actions

This Discussion