cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
512
Views
0
Helpful
2
Replies

Converted LAP - password?

jigsaw2026
Level 1
Level 1

Hi,

I've recently converted my autonomous AP (1252) to a LAP. It is now controlled by my 4402 WLC (version 4.2.112).

How can I change the password on the 1252? As I stupidly left it as the default before up I upgraded. I just used a tar file and the archive download-sw method.

Many thanks,

J

1 Accepted Solution

Accepted Solutions

Scott Fella
Hall of Fame
Hall of Fame

That password you had initially when the ap was in autonomous does not matter. Now since you have the ap joined to a wlc you need to enter the following command in the wlc cli:

config ap username password all

config ap username password

All configurations on the AP will be done by the WLC. You can't configure the LAP like an autonomous ap.

-Scott
*** Please rate helpful posts ***

View solution in original post

2 Replies 2

Scott Fella
Hall of Fame
Hall of Fame

That password you had initially when the ap was in autonomous does not matter. Now since you have the ap joined to a wlc you need to enter the following command in the wlc cli:

config ap username password all

config ap username password

All configurations on the AP will be done by the WLC. You can't configure the LAP like an autonomous ap.

-Scott
*** Please rate helpful posts ***

It worked! Thank you.

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: