02-20-2009 10:24 AM - edited 03-15-2019 04:21 PM
It seems that when going through an upgrade, if CCA hangs, its already deleted the IOS and now when I reboot the UC520, its a brick. How do I get the IOS back on the flash?
Solved! Go to Solution.
02-20-2009 10:56 AM
When you type it without parameter, it shows the environment variables that you have to set, like IP_ADDRESS=10.10.10.10
When all variable are set correctly, it will proceed to copy file to flash, or there is an option to only load image and boot.
02-20-2009 10:31 AM
Connect serial console. Boot and report output here.
02-20-2009 10:52 AM
Its in rommon mode. there is a command tftpdnld that I can use but haven't been able to figure out the syntax.
02-20-2009 10:56 AM
When you type it without parameter, it shows the environment variables that you have to set, like IP_ADDRESS=10.10.10.10
When all variable are set correctly, it will proceed to copy file to flash, or there is an option to only load image and boot.
02-20-2009 11:57 AM
It says line too large. Catch22
02-20-2009 12:07 PM
Can you type an example that actually works? I cannot find the right string.
02-20-2009 12:15 PM
I figured it out. Thanks!
02-20-2009 01:07 PM
You're welcome. Please remember to rate useful posts with the scrollbox below.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: