cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
390
Views
16
Helpful
7
Replies

UC520 Busy out not In

patrick.hurley
Level 3
Level 3

I get a busy when I pick up the phone and dial 9 but I can call into the number.

1 Accepted Solution

Accepted Solutions

Mistakes can happen. Please check it is working for you and confirm.

You can rate any post you have not rated before, anytime.

View solution in original post

7 Replies 7

paolo bevilacqua
Hall of Fame
Hall of Fame

Config problem, check your dial-peer.

Fixed it.

You don't have one, just the crap that the wizard puts in there.

Put lines actually connected in trunk-group

voice-port 0/1/2

trunk-group fxo

dial-peer voice 9 pots

destination-pattern 9T

trunkgroup fxo

The eliminate DPs 50 - 53, these are really useless.

Note, you cannot professionally configure UC520 without getting familiar with DPs, etc.

My mistake. Meant to give you a 5. Is there any way to fix it?

Yes I was using the wizard, and I saw what I did wrong and did fix it. Thanks for your help.

Mistakes can happen. Please check it is working for you and confirm.

You can rate any post you have not rated before, anytime.

Yes it works. I am testing the interface for a Cisco instructor. I was trying to be funny by pasting the whole thing in the post and saying "which one."

I found where it didn't have the right information and fixed it.

You are very helpful and thanks for being on Netpro!!

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: