HI,
I have a ASA that has the private IP address connected to the router. The router is doing the natting to a dedicated public IP address.
I have configured the VPN client settings on the firewall and when i connect the VPN client then it is connected but no communication.
On the firewall i am seeing
interface: Internet
Crypto map tag: SYSTEM_DEFAULT_CRYPTO_MAP, seq num: 65535, local addr: 172.16.16.16
local ident (addr/mask/prot/port): (0.0.0.0/0.0.0.0/0/0)
remote ident (addr/mask/prot/port): (192.168.0.1/255.255.255.255/0/0)
current_peer: 90.90.66.67, username: cisco
dynamic allocated peer ip: 192.168.0.1
#pkts encaps: 0, #pkts encrypt: 0, #pkts digest: 0
#pkts decaps: 265, #pkts decrypt: 265, #pkts verify: 265
#pkts compressed: 0, #pkts decompressed: 0
#pkts not compressed: 0, #pkts comp failed: 0, #pkts decomp failed: 0
#pre-frag successes: 0, #pre-frag failures: 0, #fragments created: 0
#PMTUs sent: 0, #PMTUs rcvd: 0, #decapsulated frgs needing reassembly: 0
#send errors: 0, #recv errors: 0
local crypto endpt.: 172.16.16.16/4500, remote crypto endpt.: 90.90.66.67/4500
path mtu 1500, ipsec overhead 82, media mtu 1500
current outbound spi: 98CACC8C
inbound esp sas:
spi: 0x8E2B293F (2385193279)
transform: esp-aes esp-sha-hmac no compression
in use settings ={RA, Tunnel, NAT-T-Encaps, }
slot: 0, conn_id: 3309568, crypto-map: SYSTEM_DEFAULT_CRYPTO_MAP
sa timing: remaining key lifetime (sec): 28451
IV size: 16 bytes
replay detection support: Y
Anti replay bitmap:
0xFFFFFFFF 0xFFFFFFFF
outbound esp sas:
spi: 0x98CACC8C (2563427468)
transform: esp-aes esp-sha-hmac no compression
in use settings ={RA, Tunnel, NAT-T-Encaps, }
slot: 0, conn_id: 3309568, crypto-map: SYSTEM_DEFAULT_CRYPTO_MAP
sa timing: remaining key lifetime (sec): 28448
IV size: 16 bytes
replay detection support: Y
Anti replay bitmap:
0x00000000 0x00000001
on the VPN Client, I am seeing,
Recieved: 0
Sent: 55587
Encrypted: 300
Decrypted: 0
Discarded: 92
Bypassed:0
It seems that VPN client encrypt the packet and sent to firewall. firewall decrypt the packet and sent to host. host replied to that response but for some reason the packet is not get encrypted on the firewall.
Can you please help me out?
Can the natting on the router have problem? I have used simple static nat command with extendable keyword.
On firewall, Crypto isakml nat-traversal 20 is configured.
Thanks
