Block incoming call

Unanswered Question
Feb 22nd, 2009

DOes any body nkow if is possible to Block a incomming call a internal number and allow just that number we want ?

I have this problem too.
0 votes
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 4 (2 ratings)
Loading.
Hythim Ali El Hadad Sun, 02/22/2009 - 16:51

Hi,

Sure you can block a specified incoming calls.

but you can do it only with h323,cme

you cann't do it with cucm unless you use h323 gateway with it.

You'll do it by rule reject /../ under voice translation-rule then apply to aprofile, then apply this profile to your pots dial-peer

wish this be helpful

Best Regards

James Hawkins Tue, 02/24/2009 - 01:00

A customer of mine had a problem with cold callers calling one of their staff on a direct number and trying to sell them kitchen equipment. This happened 4+ times a day so I was asked to try to block the caller.

As the customer used MGCP gateways the best way that I found to do this was to implement a translation pattern matching the incoming CLI and translating the call destination to the Unity pilot point.

Unity was configured to play a message telling the caller that cold calls were not welcome.

Paolo Bevilacqua Tue, 02/24/2009 - 01:48

How exactly you route by CLI in CM ? In the past it has been said that it's not possible.

Afragoso2009 Tue, 02/24/2009 - 05:11

Hi Jamesha.Its a good solution

Bu in my case I want to block all incaming call and allow just 5 or 6 that Ia want to call me

Actions

This Discussion