02-22-2009 04:36 PM - edited 03-15-2019 04:23 PM
DOes any body nkow if is possible to Block a incomming call a internal number and allow just that number we want ?
02-22-2009 04:51 PM
Hi,
Sure you can block a specified incoming calls.
but you can do it only with h323,cme
you cann't do it with cucm unless you use h323 gateway with it.
You'll do it by rule reject /../ under voice translation-rule then apply to aprofile, then apply this profile to your pots dial-peer
wish this be helpful
Best Regards
02-24-2009 01:00 AM
A customer of mine had a problem with cold callers calling one of their staff on a direct number and trying to sell them kitchen equipment. This happened 4+ times a day so I was asked to try to block the caller.
As the customer used MGCP gateways the best way that I found to do this was to implement a translation pattern matching the incoming CLI and translating the call destination to the Unity pilot point.
Unity was configured to play a message telling the caller that cold calls were not welcome.
02-24-2009 01:48 AM
How exactly you route by CLI in CM ? In the past it has been said that it's not possible.
02-24-2009 05:11 AM
Hi Jamesha.Its a good solution
Bu in my case I want to block all incaming call and allow just 5 or 6 that Ia want to call me
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide