02-23-2009 12:22 PM - edited 07-03-2021 05:13 PM
I have setup WCS logins to be managed by ACS 4.2 . I was looking over the docs and I appear to be missing something because I can't find any documentation on doing the same to the controllers. I did successfully lock myself out of the WiSM in the lab during some testing. I had to pull the plug on the lab ACS to allow local login.
Any Thoughts ?
Solved! Go to Solution.
02-24-2009 09:25 AM
Take a look at the configuration guide for the WLC. It gives you the attributes you need to configure on the ACS for TACACS.
http://www.cisco.com/en/US/docs/wireless/controller/4.2/configuration/guide/c42sol.html#wp1139569
HTH,
Steve
02-24-2009 09:25 AM
Take a look at the configuration guide for the WLC. It gives you the attributes you need to configure on the ACS for TACACS.
http://www.cisco.com/en/US/docs/wireless/controller/4.2/configuration/guide/c42sol.html#wp1139569
HTH,
Steve
02-22-2011 01:23 AM
Hey,
We have tried the steps (as found in the document) for the WiSM but it doesnt work.
Are the services (ciscowlc) and Protocol (common) still the same for Wism?
Thank you
02-22-2011 10:20 AM
It is still the same. Make sure that you sepecify the roles correctly. Have you tried just getting the WLC to work first or do you have both enabled on the ACS? What doyou see on the ACS failure logs?
02-22-2011 11:00 PM
Hello Scott,
We are configuring the role1=all , is this correct?
02-23-2011 05:21 AM
For the WLC, you are right role=ALL... make sure it is in CAPS
Here are some links you can reference:
https://supportforums.cisco.com/message/3291209
03-01-2011 04:48 AM
Hi Scott,
This one really helped us!
Thank you
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: