Unanswered Question
Feb 24th, 2009
User Badges:

hi all,

i applied following command

"privilege interface level 6 vlan-range"

but not able to c any sub-commands when i reach...

conf t--interface gig x/y--vlan-range--

only "no" is there.

Any clues

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Mohamad Qayoom Tue, 02/24/2009 - 10:29
User Badges:
  • Bronze, 100 points or more

What kind of device is are you working on?

sohaildxbfze Tue, 02/24/2009 - 11:23
User Badges:

Cisco IOS Software, Catalyst 4000 L3 Switch Software (cat4000-I5S-M), Version 12.2(25)EWA, RELEASE SOFTWARE (fc1)

Yudong Wu Tue, 02/24/2009 - 11:12
User Badges:
  • Gold, 750 points or more

you might need "all" option to enable all sub-commands when using privilege command.

sohaildxbfze Tue, 02/24/2009 - 11:24
User Badges:


"privilege interface level 6 vlan-range"

all keyword is not acceptable at all in any privilige mode exec/configure/interface

Yudong Wu Tue, 02/24/2009 - 11:49
User Badges:
  • Gold, 750 points or more

Yeah, this feature might not be in there.

Is there "priviledge vlan-range"? If not, you have to use AAA to control this.

sohaildxbfze Tue, 02/24/2009 - 13:30
User Badges:

no, but under interface level 15, i can access vlan-range then service-policy, but problem is all commands will be enabled even if i will restrict thru privilige.

Also checked CLI role based views,, but i dun know y my 4501 ios doesnt support that one too i have ip voice services


This Discussion