WLC lose the configurations parameters

Unanswered Question
Feb 24th, 2009

Hi,

I've 2 WLC managed by WCS that every night saves the configurations of both the WLCs, recently I replaced one of the two WLC with a new one (RMA Replacement)and I've uploaded the saved configuration via GUI using a TFTP server to the new WLC.The problem is that the uploaded configuration has lost all the configured security parameters(WPA, Radius servers etc.)so I had to configure them again manually.

The version of the WLCs is the 5.2 and the configuration of the WCS is the 5.2 too.

Thanks in advance.

Fabio

I have this problem too.
0 votes
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
dennischolmes Tue, 02/24/2009 - 04:08

What was the version of code on the newly replace controller before you pushed the image to it?

fcoppotelli Tue, 02/24/2009 - 05:43

The steps that I've performed are the following:

* update of the new WLC to the 5.2 version (same of the primary WLC)

* download to the controller of the previously saved configuration

* All the parameters are ok but the security, in fact I've lost the Radius servers, WPA keys and all the SSID's are in broadcast.

So i had to fix all the missing parameters manually.

Thanks

Fabio

Actions

This Discussion

 

 

Trending Topics: Other Wireless Mobility

client could not be authenticated
Network Analysis Module (NAM) Products
Cisco 6500 nam
reason 440 driver failure
Cisco password cracker
Cisco Wireless mode