WLC lose the configurations parameters

fcoppotelli · ‎02-24-2009

Hi,

I've 2 WLC managed by WCS that every night saves the configurations of both the WLCs, recently I replaced one of the two WLC with a new one (RMA Replacement)and I've uploaded the saved configuration via GUI using a TFTP server to the new WLC.The problem is that the uploaded configuration has lost all the configured security parameters(WPA, Radius servers etc.)so I had to configure them again manually.

The version of the WLCs is the 5.2 and the configuration of the WCS is the 5.2 too.

Thanks in advance.

Fabio

dennischolmes · ‎02-24-2009

What was the version of code on the newly replace controller before you pushed the image to it?

fcoppotelli · ‎02-24-2009

The steps that I've performed are the following:

* update of the new WLC to the 5.2 version (same of the primary WLC)

* download to the controller of the previously saved configuration

* All the parameters are ok but the security, in fact I've lost the Radius servers, WPA keys and all the SSID's are in broadcast.

So i had to fix all the missing parameters manually.

Thanks

Fabio