02-24-2009 02:03 AM - edited 07-03-2021 05:13 PM
Hi,
I've 2 WLC managed by WCS that every night saves the configurations of both the WLCs, recently I replaced one of the two WLC with a new one (RMA Replacement)and I've uploaded the saved configuration via GUI using a TFTP server to the new WLC.The problem is that the uploaded configuration has lost all the configured security parameters(WPA, Radius servers etc.)so I had to configure them again manually.
The version of the WLCs is the 5.2 and the configuration of the WCS is the 5.2 too.
Thanks in advance.
Fabio
02-24-2009 04:08 AM
What was the version of code on the newly replace controller before you pushed the image to it?
02-24-2009 05:43 AM
The steps that I've performed are the following:
* update of the new WLC to the 5.2 version (same of the primary WLC)
* download to the controller of the previously saved configuration
* All the parameters are ok but the security, in fact I've lost the Radius servers, WPA keys and all the SSID's are in broadcast.
So i had to fix all the missing parameters manually.
Thanks
Fabio
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: