02-24-2009 07:26 AM - edited 03-06-2019 04:12 AM
When I power up my Catalyst 3550 switch, it boots up and shows "switch:" prompt. and it takes no command afterwards. I wonder what command prompt is "switch:". Please help.
02-24-2009 07:39 AM
This means the switch has NO configuration in it.
You need to start from the begining - read the below:-
HTH>
02-24-2009 07:47 AM
you are in ROMMON mode and either you dont have image or its corrupt.
check the link of other thread have similar issue
02-24-2009 07:48 AM
That sounds like you have no IOS on the either.
Try the following:-
flash_init
load_helper
dir flash:
if there is an image in there boot from it
deja vu
if not copy one over. The complete procedure is here:
http://www.cisco.com/en/US/products/hw/switches/ps628/products_tech_note09186a0080169696.shtml
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide