3640 gatwary was connected to the bpx with t1 trunk link.
after we changed from 3640 to 2811.
when we see command "show controller t1",
we saw "T1 0/0/0 is down"
configuration is same
what is problem?
[3640]
SHI#sh controllers t1
T1 1/0 is up.
Applique type is Channelized T1
Cablelength is long gain36 0db
No alarms detected.
alarm-trigger is not set
Version info Firmware: 20000306, FPGA: 8
Framing is SF, Line Code is AMI, Clock Source is Line.
Data in current interval (21 seconds elapsed):
8799 Line Code Violations, 214 Path Code Violations
7 Slip Secs, 0 Fr Loss Secs, 21 Line Err Secs, 0 Degraded Mins
0 Errored Secs, 0 Bursty Err Secs, 0 Severely Err Secs, 21 Unavail Secs
Total Data (last 1 15 minute intervals):
363324 Line Code Violations, 11899 Path Code Violations,
459 Slip Secs, 0 Fr Loss Secs, 900 Line Err Secs, 0 Degraded Mins,
0 Errored Secs, 0 Bursty Err Secs, 0 Severely Err Secs, 900 Unavail Secs
[2811]
Router#sh controllers t1
T1 0/1/0 is down.
Applique type is Channelized T1
Cablelength is long gain36 0db
No alarms detected.
alarm-trigger is not set
Soaking time: 3, Clearance time: 10
AIS State:Clear LOS State:Clear LOF State:Clear
Version info Firmware: 20071009, FPGA: 20, spm_count = 0
Framing is SF, Line Code is AMI, Clock Source is Line.
CRC Threshold is 320. Reported from firmware is 320.
Data in current interval (773 seconds elapsed):
6658099 Line Code Violations, 148773 Path Code Violations
56 Slip Secs, 0 Fr Loss Secs, 10 Line Err Secs, 0 Degraded Mins
0 Errored Secs, 0 Bursty Err Secs, 0 Severely Err Secs, 773 Unavail Secs
[2811 config]
controller T1 0/0/0
framing sf
linecode ami
ds0-group 0 timeslots 1-24 type e&m-wink-start
[3640 config]
controller T1 1/0
ds0-group 0 timeslots 1-24 type e&m-wink-start
