Cisco 877 and Enet Encap

Answered Question
Feb 26th, 2009
User Badges:

Hello! How to configure 877 router with enet encapsulation? Multiplexing LLC-based.

My config does not work, can you tell please, what's wrong:





Attachment: 
Correct Answer by Giuseppe Larosa about 8 years 2 months ago

Hello


use the following document


http://www.cisco.com/en/US/tech/tk175/tk15/technologies_configuration_example09186a0080093e5f.shtml#configs


to implement IRB correctly you need also:


bridge ip protocol ieee

bridge 1 route ip


also to make a bridge also the lan interfaces or the Vlan1 needs to be associated to bridge-group 1.


But to be noted if you do so NAT is not needed or possible.

So you need to think about what you want to achieve


Hope to help

Giuseppe



Correct Answer by John Blakley about 8 years 2 months ago

What is your config supposed to reference? Are you connecting to a DSL provider? What type of connection is this? Did they assign you the IP address? Do you have some other device that is connecting to the router on the provider-facing side?


The config doesn't look complete, but it's hard to tell you what's missing without knowing what you're connecting to.



HTH,


John

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 5 (2 ratings)
Loading.
Correct Answer
John Blakley Thu, 02/26/2009 - 08:50
User Badges:
  • Purple, 4500 points or more

What is your config supposed to reference? Are you connecting to a DSL provider? What type of connection is this? Did they assign you the IP address? Do you have some other device that is connecting to the router on the provider-facing side?


The config doesn't look complete, but it's hard to tell you what's missing without knowing what you're connecting to.



HTH,


John

Correct Answer
Giuseppe Larosa Sun, 03/01/2009 - 09:37
User Badges:
  • Super Silver, 17500 points or more
  • Hall of Fame,

    Founding Member

Hello


use the following document


http://www.cisco.com/en/US/tech/tk175/tk15/technologies_configuration_example09186a0080093e5f.shtml#configs


to implement IRB correctly you need also:


bridge ip protocol ieee

bridge 1 route ip


also to make a bridge also the lan interfaces or the Vlan1 needs to be associated to bridge-group 1.


But to be noted if you do so NAT is not needed or possible.

So you need to think about what you want to achieve


Hope to help

Giuseppe



Actions

This Discussion