Dial, tone and dial

Unanswered Question
Feb 26th, 2009
User Badges:

Hi there,


I have a situation where I need to dial an access code, hear a tone and then dial the extension number..


It happens in my remote site, where I'm using a SRST router with a E1 (qsig) with an Avaya PBX...


Destionations that I don't need to hear the tone before calling are working fine.


Is it a router config or a CUCM config ? (CallManager 4.2)


Any help ?


Thanks.

Andrei.

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
Hythim Ali El Hadad Thu, 02/26/2009 - 02:58
User Badges:
  • Silver, 250 points or more


Hi Andrei,


You can control the dial tone from the route pattern configuration page


You can specify an access code and provide dial tone after this [ like 9 for outside calls ]

so it is from your CUCM config


But consider for any interference between these access codes and any configured DN in your network to not affect your dial tone


Wish this be helpful :)

andrei.goncalves Thu, 02/26/2009 - 03:06
User Badges:

Hi !


I found the "Provide Outside Dial Tone" configuration in the Route Pattern..


I have this pattern: 8305547XXXX


How can I tell the CUCM that the tone should be after "830" ?


Thanks a lot.

Andrei.

Actions

This Discussion