Intercom for CME

mikegrous · ‎02-26-2009

I have to hook up our CME to an interfom. I am assuming i need fxo ports and a dial plan that sends calls to that fxo port. Then into the intercom.. Is this theory correcT?

Rob Huffman · ‎02-26-2009

Hi Mike,

This is indeed the correct theory :) Just check the maufacturers specs to determine if an FXS (where you just dial up a station DN) should be used over FXO. This is a good thread that discusses these thoughts;

http://forum.cisco.com/eforum/servlet/NetProf?page=netprof&forum=Unified%20Communications%20and%20Video&topic=IP%20Telephony&topicID=.ee6c829&fromOutline=&CommCmd=MB%3Fcmd%3Ddisplay_location%26location%3D.2cbf8584

Hope this helps!

Rob

mikegrous · ‎02-26-2009

great thanks