Single Number Reach CUCM 7.0

mattcalderon · ‎02-26-2009

Installing CUCM v 7.0 and was testing Single Number Reach. Now I have the settings configured but as i was reading the Admin guide I realized that 7940/60 are not supported with SNR. Is this correct?

http://www.cisco.com/en/US/docs/voice_ip_comm/cucm/admin/7_0_1/ccmfeat/fsmobmgr.html#wp1127918

testeven · ‎02-26-2009

Hi!

Those phones are supported. Please refer to the SRND:

"Mobile Voice Access and Enterprise Feature Access are supported for all incoming PSTN devices capable of

sending DTMF digits. Cisco Unified IP Phone support for these features is the same as for Mobile Connect

(see Mobile Connect Phone Support)."

Mobile Connect Phone Support

https://www.cisco.com/en/US/docs/voice_ip_comm/cucm/srnd/7x/mobilapp.html

Hope this helps!

Regards,

Teresa.

Regards, Tere. If you find this post helpful, please rate! :)

mattcalderon · ‎02-26-2009

I have read through the link that you have supplied, and it does seem to mention the 7960/40 as applicable phone types but what about the mention in the CUCM admin guide? It does not specify that phone type.

FYI..I did get it working.