Nicholas Matthews Fri, 02/27/2009 - 05:20
User Badges:
  • Red, 2250 points or more

You can check 'show voice dsp detail | i default'. If that spits an error message you have a file in flash changing your DSPware.


Vitor Afonso St... Fri, 02/27/2009 - 09:52
User Badges:

Be sure if there some overlap in your dial plan scheme!

Check here (Assumes that you're using Cisco CallManager in your scenario...) for more information:

Cisco Unified Communications SRND Based on Cisco Unified Communications Manager 5.x - Dial Plan [Cisco Unified Communications Manager (CallManager)] - Cisco Systems:



robbie.teo Sun, 03/01/2009 - 18:24
User Badges:

Sorry for the lack of details....

I'm using UCM 6.1 connected via FXO

currently got only 2 ip phones DN 777 and 888

My dial pattern is 6.@ and 9.@

Is there any problem with my setup that cause the delay in dailing out?


This Discussion