×

Warning message

  • Cisco Support Forums is in Read Only mode while the site is being migrated.
  • Cisco Support Forums is in Read Only mode while the site is being migrated.

Bandwidth needed for IPSec tunnels

Unanswered Question
Feb 27th, 2009
User Badges:

Hi All,

I have to install an ASA 5520 and configure approximately 600 Site-to-Site IPSec tunnels. My question is... how much bandwidth is needed for this to work? How much bandwidth approximately consumes each tunnel? Is there a way that I get a number?

Thank you!

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
auraza Fri, 02/27/2009 - 11:02
User Badges:
  • Cisco Employee,

The bandwidth on each tunnel can vary. It all depends on how much traffic is being pushed through the tunnels. You can monitor the traffic using SNMP.

Actions

This Discussion