cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
506
Views
0
Helpful
1
Replies

Bandwidth needed for IPSec tunnels

fedecotofaja
Level 1
Level 1

Hi All,

I have to install an ASA 5520 and configure approximately 600 Site-to-Site IPSec tunnels. My question is... how much bandwidth is needed for this to work? How much bandwidth approximately consumes each tunnel? Is there a way that I get a number?

Thank you!

1 Reply 1

auraza
Cisco Employee
Cisco Employee

The bandwidth on each tunnel can vary. It all depends on how much traffic is being pushed through the tunnels. You can monitor the traffic using SNMP.

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: