Incoming caller id

Unanswered Question
Feb 27th, 2009

Hello, we have cucm 5.1 when we receive call we see Siemens and the caller number , siemens was the old phone system , how can i block the siemens writing allowing the caller id only?thanks.

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
Kenneth Mohammed Fri, 02/27/2009 - 13:50

Hello,

Are these callers calling from phones connected to a Siemens PBX, or are the calls coming from the PSTN directly to the CUCM?

Marco Villani Mon, 03/02/2009 - 07:11

This is what i see from debug isdn, i need to edit the siemens. thanks.

Bearer Capability i = 0x8090A2

Standard = CCITT

Transfer Capability = Speech

Transfer Mode = Circuit

Transfer Rate = 64 kbit/s

Channel ID i = 0xA98391

Exclusive, Channel 17

Display i = 'SIEMENS'

Marco Villani Tue, 03/03/2009 - 06:41

the Gateways are two 3845 using MGCP. they are configured with PRI and CAS ,what i was told is that the guy who configured the system asked them if the want to see anything on the phone and they said siemens. i just can't find where to change this.

Actions

This Discussion