02-27-2009 01:45 PM - edited 03-15-2019 04:31 PM
Hello, we have cucm 5.1 when we receive call we see Siemens and the caller number , siemens was the old phone system , how can i block the siemens writing allowing the caller id only?thanks.
02-27-2009 01:50 PM
Hello,
Are these callers calling from phones connected to a Siemens PBX, or are the calls coming from the PSTN directly to the CUCM?
02-27-2009 02:10 PM
All of the incoming call,even from a cell phone and still shows Siemens.
03-02-2009 07:11 AM
This is what i see from debug isdn, i need to edit the siemens. thanks.
Bearer Capability i = 0x8090A2
Standard = CCITT
Transfer Capability = Speech
Transfer Mode = Circuit
Transfer Rate = 64 kbit/s
Channel ID i = 0xA98391
Exclusive, Channel 17
Display i = 'SIEMENS'
03-02-2009 09:47 AM
To what are you connected ?
Are you using H.323 ?
03-03-2009 06:41 AM
the Gateways are two 3845 using MGCP. they are configured with PRI and CAS ,what i was told is that the guy who configured the system asked them if the want to see anything on the phone and they said siemens. i just can't find where to change this.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide