Extension Mobility - UC520

Unanswered Question
Feb 28th, 2009
User Badges:

Hi All,

We installed our system in November of last year - so far all good, however I want to now enable extension mobility to allow users to switch between desks as well as add remote access for our sales guys. I have not been able to find any sample configuration guides and was hoping someone could share or point me in the right direction.



  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
sanjayist Mon, 03/02/2009 - 03:22
User Badges:

Hi Gary,

Create device profiles for each user and then associate their phones with that.All subscribe all the phones to extension mobility servcies so that phone can show EM options

paolo bevilacqua Mon, 03/02/2009 - 03:52
User Badges:
  • Super Gold, 25000 points or more
  • Hall of Fame,

    Founding Member

hythamhadad, sanjayist

What you're missing here, is that the OP does NOT have CCM, he has CME (UC520).

g.portellas Mon, 03/02/2009 - 18:10
User Badges:

Correct, this is a UC520 system.

Cisco UC520-48U-T/E/F-K9 (MPC8358) processor (revision 0x202) with 249856K/12288K bytes of memory.

Processor board ID FTX1234Y01U

MPC8358 CPU Rev: Part Number 0x804A, Revision ID 0x20

56 User Licenses

10 FastEthernet interfaces

24 Serial interfaces

2 terminal lines

1 Channelized T1/PRI port

4 Voice FXO interfaces

4 Voice FXS interfaces

1 Voice MoH interface

1 cisco service engine(s)

128K bytes of non-volatile configuration memory.

125440K bytes of ATA CompactFlash (Read/Write)

Configuration register is 0x2102


This Discussion