IP phone 7980

Unanswered Question
Mar 1st, 2009
User Badges:

Hii experts,,


I have an issue with my phone 7980 when I try to make a call throught the PRI it is only ring once then busy tone.


My VGW is 2811 and the PRI configuration as below:


interface Serial0/0/0:15

no ip address

encapsulation hdlc

isdn switch-type primary-net5

isdn incoming-voice voice

isdn bchan-number-order ascending

no cdp enable



voice-port 0/0/0:15

bearer-cap Speech


And I configure a voice calss codec with G711 and g729 codecs and applied it to the Voip dial peer.


PLZ note that the calls therougt VGW 3825 are working fine.

Thanks..

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
Anonymous (not verified) Fri, 03/06/2009 - 05:42
User Badges:

What type of protocol is being used in the CCM setup for the gateway? MGCP or H323?

amarmn1975 Tue, 03/10/2009 - 21:24
User Badges:

Hii,,


Thanks for all .. I found a solution for thais problem, it just was a codec problem. I it is ok now..


Thankks..

Actions

This Discussion