Netflow data on saturated link

Unanswered Question
Mar 1st, 2009

I've got a serial interface on a 2811 router that has been showing an rx load of 252/255 for about 48 hours.

I've got netflow enabled on it and when I put an ACL on the serial interface to block the offending IP address it does not seem to be working. I've got the log parameter on there and its not showing in the log and the rx load is not decreasing.

Netflow shows it as protocol 27 and the source and destination addresses are not any of the networks configured on this router.

What is going on here? Thanks for any help on this.

I have this problem too.
0 votes
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)


This Discussion