Solved: set up date and time on call manager 6.1(2)

rachelau_2005 · ‎03-03-2009

Hi

I am using call manager 6.1(2)

The time on the IP phones are wrong.

I have set up the time zone under the date/time group configuration page on the call manager.

Where can I set the correct date and time on the cisco call manager 6.1(2)?

and how can I synchroize the time betweeo sub and pub for the call manager 6.1(2).

Thanks

kind regards

Rachel

Eldho E Kuriakose · ‎03-03-2009

yes...

In Os administration page of pub > settings > time

rate if useful..

Eldho E Kuriakose · ‎03-03-2009

you ca set time in o/s administration page or you can map it to an ntp server

subscriber getting its time from publisher

But for phones you can set ntp reference for phones in administration page

note: In command prompt check

show timezone config

show timezone list

utils ntp config

utils ntp restart

utils ntp start

utils ntp status

rachelau_2005 · ‎03-03-2009

Hi

if I dont have any ntp server that I can connect to it.. is there any way to just set the date and time on the call manager 6.1 ?

when I was using call manager 4.2.1, I set up the time on the call manager directly previously... is it possible for call manager 6.1(2)?

basically i just need to sychronize the time for pub, sub and unity.

thanks

Eldho E Kuriakose · ‎03-03-2009

yes...

In Os administration page of pub > settings > time

rate if useful..

rachelau_2005 · ‎03-04-2009

Yes,

its working now, thanks