CUE can access MS-Exchange server?

Unanswered Question
Mar 3rd, 2009
User Badges:

Hi all,

My customer hope that CUE access local exchange server directory.Does it supported?If it can't access directly, may I use VPIM between Unity with MS-Exchange and Unity Express to reach it?


brook

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
Ronald Spencer Thu, 03/12/2009 - 18:07
User Badges:

i don't know if CUE can access the local exchange directory, though I would suspect not. Regarding the VPIM connection, here are the settings for that (taken from http://pushkarbhatkoti.wordpress.com/category/cisco-unity-to-cue-vpim-networking-in-5-minutes/)


How to configure VPIM in 5 minutes - mystry solved!!

December 19, 2008 at 2:14 pm | In 1, Cisco Unity to CUE VPIM networking in 5 minutes | No Comments


I have looked around a lot of document and came through various documents and finally couldn't find what I was after. Then after reading heaps of crap, I made a short doc which really shrinks down the VPIM.


Basic Concept:

VPIM : Based on SMTP & MIME (Multi-Purpose Internet Mail Extension)


Message content components:


- spoken name

- forwarded fax and text messages.

- vCard (phone number, text name and email address)

VPIM Addresses: [email protected]


Dial ID vs. Location


- Primary Location (Default Location)

- Delivery Locations

Voice Connector: This encodes Voice mail into VPIM format.


VPIM Subscriber ??

[VPIM:_]


CiscoUnity4.0.5CD1\ADSchemaSetup\ADSchemaSetup.exe

- select only [Exchange 2000 or Exchange 2003 VPIM Connector]


CiscoUnity4.0.5CD1\VoiceConnector-Ex2000\Install.exe


routing group

routing group connector


CUE settings:



hostname CUE


ip domain-name cue.cisco.com

ip name-server


network location id 408

email domain yyy.cisco.com (put your actual here)

name “Unity”

voicemail extension-length 4

enable

end location


network location id XXX (where XXX = sitec location ID)

email domain 10.1.1.253 (CUE IP)

name “CUE”

voicemail extension-length 8

enable

end location


network local location id XXX

----------------------

Primary Locations

- yyy.cisco.com for Domain Name(SMTP)

- Dialing Domain leave blank.

- Update Addressing Options = Global directory / Global directory


Delivery Locations

==============


- [SMTP domain name] = 10.1.1.253 (CUE IP)

- Check [Sender's recorded name]

- Check [Sender's vCard]

----------------------


Troubleshooting commands:

show network locations

show network detail location id …

show network detail local

show network queues


How to send vpim messages:


Press messege button of your phone

option#2 - saying something leave message (thats how we send vpim message), follow the cisco IVR lady.

You need to dial location ID# then phone number for example 408+phone number where 408 is hq site vpim site “Id”

Hope this helps to some folks who are struggling with VPIM mistry!


-Push Bhatkoti


CCIE voice#21569


Actions

This Discussion