MARS Doesn't display attack diagram

Unanswered Question
Mar 4th, 2009
User Badges:

Hi Friends,


I have added the devices in the DC to the CS MARS. Following are the devices added and discovered

1) 6509 switch

2) FWSM module

3) IPS Sensor

4) branch router


but the issue is iam not getting the attack diagram in the dash board... it is just blank.


any help is appreciated.


Thanks

Ravi

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
Farrukh Haroon Fri, 03/06/2009 - 22:37
User Badges:
  • Red, 2250 points or more

Attack diagarm is usually visible if both endpoints (source/destination) are available on the map. If the attack involves some internet address the diagram will not display. Try to check any attack which involves source/destination from the local network.


Regards

Farrukh

Mubasher Sultan... Tue, 05/05/2009 - 00:46
User Badges:

How can we check the CPU Utilization & Memory Utilization on the box?


Did you get any reply from the TAC about the memory leak?


Appriciate your help.

Actions

This Discussion