cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
2755
Views
5
Helpful
3
Replies

EEM and SNMP

julien.lefloch
Level 1
Level 1

Hello,

Maybe a question for Joe about EEM!

I would like to pool a CUCM MIB with an EEM applet on a cisco gateway running IOS 12.4(22)Tx.

Is it be possible with EEM 3.0 and the new ipaddr option available? or must this ip address be absolutely a NMS ip?

--> action label info type snmp oid oid-value {get-type {exact | next} [community community-string] | set-type oid-type oid-type-value community community-string} [ipaddr ip-address]

If anyone can help me!

Thanks.

1 Accepted Solution

Accepted Solutions

Make sure you have the following configured on the router:

snmp-server manager

Without the SNMP manager, you cannot make SNMP requests.

View solution in original post

3 Replies 3

Joe Clarke
Cisco Employee
Cisco Employee

That's right. The ipaddr keyword allows you to query a remote device. For example:

event manager applet snmptest

event none

action 1.0 info type snmp oid 1.3.6.1.2.1.1.1.0 get-type exact community public ipaddr 10.1.1.1

action 2.0 syslog msg "Read $_info_snmp_value"

Router#event manager run snmptest

Mar 4 17:38:14.326: %HA_EM-6-LOG: snmptest: Read Cisco Internetwork Operating System Software

IOS (tm) RSP Software (RSP-JSV-M), Version 12.3(20a), RELEASE SOFTWARE (fc2)

Technical Support: http://www.cisco.com/techsupport

Copyright (c) 1986-2007 by cisco Systems, Inc.

Compiled Sat 21-Jul-07 03:53

Hi Joe,

I agree with your example but for me it doesn't work! x.x.x.x is a CUCM with a public snmp community configured.

event manager applet snmptest

event none

action 1.0 info type snmp oid 1.3.6.1.2.1.1.1.0 get-type exact community public ipaddr x.x.x.x

action 2.0 syslog msg "Read $_info_snmp_value"

!

end

HQ8-CUBE2#event manager run snmptest

HQ8-CUBE2#sh logging | begin /*Mar 5 14:

*Mar 5 14:15:19.184: %SYS-5-CONFIG_I: Configured from console by vty0 (10.26.0.173)

*Mar 5 14:15:22.096: %SYS-5-CONFIG_I: Configured from console by vty0 (10.26.0.173)

*Mar 5 14:16:47.920: %HA_EM-7-FMFD_SNMP_REQ_FAILED: fh_fd_do_snmp_request_remote: SNMP request failed

*Mar 5 14:16:47.924: %HA_EM-3-FMPD_UNKNOWN_ENV: fh_parse_var: could not find environment variable: _info_snmp_value

*Mar 5 14:16:47.924: %HA_EM-3-FMPD_ERROR: Error executing applet snmptest statement 2.0

HQ8-CUBE2#

Thanks.

Make sure you have the following configured on the router:

snmp-server manager

Without the SNMP manager, you cannot make SNMP requests.

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Innovations in Cisco Full Stack Observability - A new webinar from Cisco