03-05-2009 12:28 AM - edited 03-06-2019 04:24 AM
Hi all,
I seem to recall, in this forum a little while ago a topic that I think was about the capability to change the cpu percentages and/or queues on a layer 3 switch or something..??
If memory serves, this capability is in a layer 3 switch and can be changed if the switch was only going to be used as a layer 2 device..
Does anyone remember that or am I dreaming?
I'm hoping someone can jog my memory, or even better still, post a link to a document about it.
Thanking you in advance!!
Brad
Solved! Go to Solution.
03-05-2009 12:35 AM
Hi,
Are you refering to the SDM templates? On some of the smaller switches (ie 3750, 3560) you can apply a template.
This allocates more system resources towards layer 2 or layer 3 operations depending on what you're using your switch for
Just search for "SDM templates" on cisco.com or chesk this
Regards
03-05-2009 12:35 AM
Hi,
Are you refering to the SDM templates? On some of the smaller switches (ie 3750, 3560) you can apply a template.
This allocates more system resources towards layer 2 or layer 3 operations depending on what you're using your switch for
Just search for "SDM templates" on cisco.com or chesk this
Regards
03-05-2009 01:58 AM
Mate, that is exactly what I was after.. thanks a lot!!!
Brad
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: