cant use rommon mode

Unanswered Question
Mar 5th, 2009

When I boot my cisco 2620xm it show wierd characters and wont let me do anything. First this was cuased by a power failure when hte router was upgrading. Second I have used the jumpers to reset the console speed with no luck. finally i have removed all modules to see if they were the problem but its no use. How do I fix this router? Its used in a classrooms lab setup.

I have this problem too.
0 votes
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Giuseppe Larosa Fri, 03/06/2009 - 00:05

Hello Harry,

a C2620xm should have a software based config-register.

try to connect to the console using different speeds until you see readable output

Hope to help


Leo Laohoo Fri, 03/06/2009 - 16:05


You will have to patiently try out every speed there is on the console terminal. No choice.


This Discussion