03-05-2009 01:44 PM - edited 03-04-2019 03:49 AM
I have cisco 7609 with two SUP-720, WISM, and ethernet modules. Currently I have IOS s72033_rp-ADVIPSERVICESK9_WAN-M), Version 12.2(33)SRA5,
Because this IOS is not detecting the WISM. I am trying the IOS s72033-adventerprisek9_wan-mz.122-18.SXF15 that i have successfully installed in 6513 catalyst which also include the WISM. But now same IOS for 7609 is not working for me.
I followed the below mention steps.
copy ftp: disk0:
Address or name of remote host [192.168.1.11]?
Source filename [s72033-adventerprisek9_wan-mz.122-18.SXF15.bin]?
Destination filename [s72033-adventerprisek9_wan-mz.122-18.SXF15.bin]?
Accessing ftp://192.168.1.11/s72033-adventerprisek9_wan-mz.122-18.SXF15.bin...
Loading s72033-adventerprisek9_wan-mz.122-18.SXF15.bin !!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!
[OK - 63477880/4096 bytes]
copy disk0:s72033-adventerprisek9_wan-mz.122-18.SXF15a.bin slavedisk0
boot system flash disk0:s72033-adventerprisek9_wan-mz.122-18.SXF15a.bin
but no luck. The Router 7609 goes to mointor mode after this.
When i verify the IOS it gave me following error
ATCT-BD-ULV02-7609-01#verify di
7609-01#$0:s72033-adventerprisek9_wan-mz.122-18.SXF15.bin
%Filesystem does not support verify operations
Verifying file integrity of disk0:s72033-adventerprisek9_wan-mz.122-18.SXF15.bin
%WARNING: Signature not found in file disk0:s72033-adventerprisek9_wan-mz.122-18.SXF15.bin.
ATCT-BD-ULV02-7609-01#
00:18:34: %SIGNATURE-4-NOT_PRESENT: %WARNING: Signature not found in file disk0:s72033-adventerprisek9_wan-mz.122-18.SXF15.bin.
00:18:34: %SIGNATURE-4-NOT_PRESENT: %WARNING: Signature not found in file disk0:s72033-adventerprisek9_wan-mz.122-18.SXF15.bin.
and even with old image i m not able to write configuration on standby. I m gettin following error.
ATCT-BD-ULV02-7609-01#
00:09:34: %PCMCIAFS-SP-5-DFS_CLOSE_ERR: Error during close of the file s72033-adventerprisek9_wan-mz.122-18.SXF15.bin. Failed to flush the remaining file data.
ATCT-BD-ULV02-7609-01#
*** Illegal Opcode Exception ***
PC = 0x8010dce0, Cause = 0x28, Status Reg = 0x30409003
00:03:32: %PFREDUN-SP-4-BOOTSTRING_INVALID: The bootfile slavesupboot-disk:/s72033-advipservicesk9_wan-mz.122-33.SRA5.bin is not present in standby
00:03:34: %PFINIT-SP-5-CONFIG_SYNC: Sync'ing the startup configuration to the standby Router. [OK]
Please let me what i m missing and which IOS image required for 7609.
Please also let me know that the steps i used for upgrade are right or not.
03-06-2009 09:27 AM
can anybody help me out.
03-06-2009 04:02 PM
You copied a file called "s72033-adventerprisek9_wan-mz.122-18.SXF15.bin" from your FTP to Disk0 without a problem.
But you tried to copy "s72033-adventerprisek9_wan-mz.122-18.SXF15a.bin" from Disk0 to SlaveDisk0. Do you have "s72033-adventerprisek9_wan-mz.122-18.SXF15a.bin" in Disk0?
03-08-2009 12:12 PM
type show disk0: and slavedisk0: or dir disk0: and see if same image is there on both disks, also from rommon try to run the image directly by boot command.. see if it helps
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: