Block E.164 Registration On GK

s.carruthers · ‎03-05-2009

Is there a way to disallow dynamic E.164 number registration from a CME to a GK without specifying no-reg after each ephone-dn?

The logical commands for this would seem to be:

On the GK - no ras rrq dynamic prefixes

On the CME - voice service voip > no ras rrq dynamic prefixes

But neither of these commands has the effect desired - ephone-DNs continue dynamic registration. Is the no-reg specification per ephone-dn the only possibility?

Nicholas Matthews · ‎03-05-2009

You can do this globally in CME:

telephony-service

max-dn no-reg [primary] [both]

hth,

nick

mlitka · ‎03-12-2009

Do you have to do something else to get this going? I have an existing configuration I applied this to.

The command applied number no-reg both to all my ephone-dn's.

I then issued a no gateway, gateway to re-register it with the gatekeeper but the e.164 numbers are still there.

I did verify on the gatekeeper that the registration goes away and comes back.

Any ideas?

wsol · ‎03-13-2009

You need reload gatekeeper and CCME router