03-06-2009 12:41 PM - edited 03-06-2019 04:26 AM
Attempting to build a 6509 with Supervisor 2s in module 1 & 2 - OS is
CatOS 8.5.2.
When powered on with both sups in place, the system keeps repeating "Failed in stat 0" and will not start. We moved the modules to a 6506 and it booted properly.
The 6509 will boot with a single Supervisor 2 in module 1. We suspect a hardware issue with the chassis - is there anything we should check before opening a TAC case?
03-06-2009 12:52 PM
What happens when you boot with one installed, allow it to load, then insert the second module.
If it stays up, issue the command :-
show module 2
to get some more details.
03-06-2009 01:11 PM
We had tried that. The switch stayed up, but didn't see module 2 at all - not listed when we did "show module"
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: