I have this weird issue with the VG248. I have a UCM 6.1 and the VG248 is used to integrate with a third-party voice-mail application.
It was going fine until all of a sudden, I noticed that it is in a constant state of restart.
It sometimes stays up long enough for me to ping it then it goes down again.
It sometimes even when it's up, the ethernet port goes down and so it won't register on the callmanager.
I upgraded the software to version 1.3.2 and i verified that it's loading it correctly, by display->Version
The error log is not showing anything strange other than TFTP timeout, which is explainable since the ethernet is down.
I get this strange error, which I am not sure if it has anything to do with anything:
"Warning: 3.3 volts supply too low: 2.757 volts"
Point is i'm not sure if it's a hardware failure or a corruption of the softwar eimage?
Really appreciate the response.