I'm attemtping to setup a small lab.
I have one 3550 SMI
I have several VLANs defined, see config below. I have a DHCP server - 10.10.10.2
And a route to the rest of the network via 192.168.0.90.
From the switch, I can ping the VLAN interfaces (as long as there's a device on the VLAN). Howver, there are two problems:
1- DHCP doesn't work, the discovery never makes it to the server
2. I'm unable to ping clients (which are statically addressed) in the other VLANS.
The routing table looks correct.
From the switch I can ping the outside world.
My config is attached.
I would sincerely appreciate any help.
This is clearly a L2 issue. Where are the server and client connected. I only see 3 access port in vlan1010 (fa0/2,fa0/3,fa0/4) and these 3 ports are down in the output you provided. fa0/1 is a trunk port and carries vlan 1010. Are the server and client connected to another switch? If so, is the trunk port up?