03-08-2009 09:29 PM
Hi All,
Been really busy with a new ACE implementations... hectic :)
AW, small question to all. We have the ACE (appliance) configured to transparently redirect http traffic of a service providers client base to a cache.
ACE is configured in bridged mode. Client side vlan and internet side vlan is in bvi 10 which is associated with an IP.
The servers are in a separate subnet/vlan.
Now, I need to remote access the ACE from the client side via telnet. I've applied the default "remote-mgmt-access" policy to the client vlan. Now since the clinet vlan is bridged, I have no ip addrs in the client side interface to telnet in to. I tried to telnet in to the bvi, but it did not work. I tried to setup another vlan with an IP address in the ACE, and then to telnet in to it from the client side, still no luck
Any idea on how to get this done ?
DIN
03-09-2009 09:06 AM
03-10-2009 07:39 PM
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: