how to config Aironet series 1000

Unanswered Question
Mar 9th, 2009
User Badges:

Hi, after a hard work of searching, im here asking for your calificated help. I've an Aironet AP-1010 access point but it seems to be pre-configurated by the people who last used it. I need restore it to original configurations and then set it up.

Thanks

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
Leo Laohoo Mon, 03/09/2009 - 16:49
User Badges:
  • Super Gold, 25000 points or more
  • Hall of Fame,

    The Hall of Fame designation is a lifetime achievement award based on significant overall achievements in the community. 

  • Cisco Designated VIP,

    2017 LAN, Wireless

I don't think you can configure an AP 1000 for Autonomous "All the 1000 Series APs support only LWAPP." (http://www.cisco.com/en/US/products/hw/wireless/ps430/products_qanda_item09186a00806a4da3.shtml)


However, if you want to perform password-recovery, follow the procedures below:


http://www.cisco.com/en/US/products/hw/wireless/ps430/products_password_recovery09186a00800949d0.shtml


Hope this helps.

Actions

This Discussion