how to config Aironet series 1000

spgiuliano · ‎03-09-2009

Hi, after a hard work of searching, im here asking for your calificated help. I've an Aironet AP-1010 access point but it seems to be pre-configurated by the people who last used it. I need restore it to original configurations and then set it up.

Thanks

Leo Laohoo · ‎03-09-2009

I don't think you can configure an AP 1000 for Autonomous "All the 1000 Series APs support only LWAPP." (http://www.cisco.com/en/US/products/hw/wireless/ps430/products_qanda_item09186a00806a4da3.shtml)

However, if you want to perform password-recovery, follow the procedures below:

http://www.cisco.com/en/US/products/hw/wireless/ps430/products_password_recovery09186a00800949d0.shtml

Hope this helps.