03-09-2009 07:15 PM - edited 07-03-2021 05:17 PM
Hi All,
Has somebody work with adding Autonomous AP to TACACS. I can access the cli mode after I added the same; but I am facing issue with the GUI mode. When I access the GUI mode; the debug says authentication failed.
Can somebody help me on the same
Thanks
NikhiL
03-10-2009 08:42 AM
Try entering the enable secret for the password without entering anything for the username. You might just be configured to use local authentication rather than ACS. Default enable secret is "Cisco", note the capital C.
If that works, check your telnet (vty) configuration. If you need assistance with that, post your config and someone would likely be able to pinpoint the problem.
Jeff
03-11-2009 11:05 PM
Jeff,
Thanks for the mail
The issue is related with a bug CSCeb52431, but the bug says it is resolved in 12.3(7)JA. But it still exists after the same also
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide