cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
447
Views
0
Helpful
2
Replies

Adding Autonomous access points to TACACS

nikhilcherian
Level 5
Level 5

Hi All,

Has somebody work with adding Autonomous AP to TACACS. I can access the cli mode after I added the same; but I am facing issue with the GUI mode. When I access the GUI mode; the debug says authentication failed.

Can somebody help me on the same

Thanks

NikhiL

2 Replies 2

jeff.kish
Level 7
Level 7

Try entering the enable secret for the password without entering anything for the username. You might just be configured to use local authentication rather than ACS. Default enable secret is "Cisco", note the capital C.

If that works, check your telnet (vty) configuration. If you need assistance with that, post your config and someone would likely be able to pinpoint the problem.

Jeff

Jeff,

Thanks for the mail

The issue is related with a bug CSCeb52431, but the bug says it is resolved in 12.3(7)JA. But it still exists after the same also

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: