FXO incoming call diverted to "always off-hook" FXO/FXS/E&M port

Unanswered Question
Mar 9th, 2009
User Badges:

I am trying to find out if its possible to divert an incoming PSTN call through an FXO (origination) port to a FXO/FXS/E&M (destination) port (on the same router) which is always open or off-hook . The incoming call can be automatically answered without picking up the phone handset (which is connected to the destination FXO/FXS/E&M port).


Something like this -


PSTN ---> FXO ---> FXO/FXS/E&M (always off-hook) ---> phone set


I have tried the config below but it requires someone to answer (off-hook) the phone when it rings.


voice-port 1/0/0 (FXO port with PSTN line)

connection plar 100


dial-peer voice 100 pots

destination-pattern 1..

port 1/1/0 (E&M port with PBX phone line)


Thanks very much.

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
Nicholas Matthews Tue, 03/10/2009 - 15:36
User Badges:
  • Red, 2250 points or more

Try using the 'connection trunk ' command with dial peers that point numbers to both sides.


So you could have something like this:


voice-port 0/0/0

connection trunk 1001


voice-port 0/0/1

connection trunk 1002


dial-peer voice 1 pots

destination-pattern 1001

port 0/0/1


dial-peer voice 2 pots

destination-pattern 1002

port 0/0/0




hth,

nick

pllim Thu, 03/12/2009 - 23:42
User Badges:

Follow your config. I have a question. Do i need to configure a dial-peer voice voip because the 'show voice port summary' shows the connection trunk is not operating.


# show voice port summary


PORT CH SIG-TYPE ADMIN OPER STATUS STATUS EC

====== == ========== ===== ==== ======== ======== ==

1/0/0 -- fxo-ls up dorm trunked trunked n

1/0/1 -- fxo-ls up dorm trunked trunked n






pllim Mon, 03/16/2009 - 22:44
User Badges:

I have put in a dial-peer voice voip in the config. This time the connection trunk is operating.


# show voice port summary


PORT CH SIG-TYPE ADMIN OPER STATUS STATUS EC

====== == ========== ===== ==== ======== ======== ==

1/0/0 -- fxo-ls up up trunked trunked n

1/0/1 -- fxo-ls up up trunked trunked n


The problem now is when I call the PSTN line connected to FXO port 1/0/0, it is always engaged. What should I do?

Actions

This Discussion