on multilink interface ip load sharing per-packet is not available on 7609

sgopikrishnan · ‎03-10-2009

7609(config)# int mul 11

7609(config-if)#ip load-sharing

7609(config-if)#ip load-sharing ?

per-destination Deterministic distribution

7609-2(config-if)#ip load-sharing

------

> The card is STM1/OC3 with SFP modules in it

> dCEF is enabled,

> is there any hidden command or any software bug, i am using 12.2(33)SRA5 or suggest IOS which supports this

------

the following command is also not available

Globalconfig#hw-module slot <no> per-packet

it is very urgent kindly help me out

Peter010101 · ‎03-10-2009

ip load-sharing is used under the physical interface.

With a multi link you are already load sharing with the circuits that are bundled.

sgopikrishnan · ‎03-10-2009

the same is working fine(on Multilink) in 7206 router. But

the physical interface on 7609 also is displaying the same (per-packet is not seen)