03-11-2009 04:13 AM - edited 03-18-2019 10:39 PM
Hi all,
how can i make read-only user to access the unity 4.2 - the administration system
just to review.
Thanks In advance
03-11-2009 06:33 AM
In Unity admin, go to Class of Service and create a new CoS. In the new CoS, go to System Access and give it read access to administration. Then create a new subscriber and assign this CoS.
Hope this helps.
Brandon
03-11-2009 07:03 AM
Thanks to you for your help
i tried but i am facing below error :
Server.CreateObject(AvSaLocalization.AvSaLocalization.1) failed.
This is most likely an error with a DLL, probably AvSaLocalizationSvr.dll or perhaps AvSaLocaleInfoSvr.dll.
Check that these files are present, and registered with REGSVR32.
Also be sure that the appropriate MsgStoreRes.dll file is present.
Cannot continue.
(From: Global.asa: hr=0x80070005)
03-11-2009 07:07 AM
Have you tried registering the referenced DLLs using regsvr32?
Brandon
03-11-2009 07:28 AM
This link should get you fixed up:
http://www.cisco.com/en/US/products/sw/voicesw/ps2237/products_tech_note09186a00801651f9.shtml#k1
Hope that helps,
Brad
03-11-2009 07:58 AM
Hi ,
some thing strange happen,,
i can access the unity admin page without any authentication after i made the above procedure (Cisco Dec.)
what have i do to solve this issue,
just i need read only user
03-11-2009 08:24 AM
You'll need to specify a new Class of Service and configure the System Access portion of it for whatever you want your user to have access to.
Brad
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide