making a 1240G access point FAT

Unanswered Question
Mar 11th, 2009

Hi,

I run a large wlan. however i have a branch site that requires just 1 cisco accesspoint ( i have a spare 1240g ap )

I would like to make this a standalone AP connected to the lan which can manage client authentication and association. It will be connected to cisco poe switch and the site is run by a cisco router.

the laptops will require static addresses.

whats the easiest way to play around with an test a 1240g ap in fat mode ?

also is there any other new ap`s perhaps a 5ghz or n radio device that can be run solo ?

cheers

Phill

I have this problem too.
0 votes
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
Leo Laohoo Wed, 03/11/2009 - 15:53

Hi Phil,

Have you tried using H-REAP?

H-REAP Modes of Operation Configuration Example

http://www.cisco.com/en/US/tech/tk722/tk809/technologies_configuration_example09186a00807cc3b8.shtml

H-Reap Design and Deployment Guide

http://www.cisco.com/en/US/products/ps6087/products_tech_note09186a0080736123.shtml

Hybrid Remote Edge Access Point (H-REAP) Basic Troubleshooting

http://www.cisco.com/en/US/tech/tk722/tk809/technologies_tech_note09186a008081103d.shtml

Hope this helps.

meggerman Thu, 03/12/2009 - 05:25

Hi leolaohoo,

thanks for your replyi will read these documents.

cheers

Phill

Actions

This Discussion